Useful Tips to Get the Most out of your Auger Attachment

Useful Tips to Get the Most out of your Auger Attachment

One of the most frequently asked questions about augers is how people can get the most out of them. The reason why it is widely asked, especially by newbies, is because some people do not get to enjoy their drilling machines. However, the why reason people do not get the most of their drilling equipment is due to poor use of these machines. That results in high rate of wear down of wear parts hence the frequently auger teeth replacement.

If you want to get the most out of your drilling equipment, there are a couple of things that you must do write. These are things that make the operation of the machine easier and improves/maintains the high performance and productivity of the machine. Here are tips that you should follow:

Go With the Flow

One of the basic tips that every operator should adhere to is going with the flow of the machine. The combination if the auger head attachment and the power developed by the source (skid steer or excavator amongst others) is an essential factor to consider. For you to get the most out of your machine, the hydraulic flow and pressure must be enough to drive the auger attachment. The form of coupling between the engine and auger head attachment. However, direct coupling or direct drives are the most recommended. They have a great hydraulic flow and pressure.

Smooth operation

How the machine is operated is crucial to its performance and productivity. If you are operating your machine roughly, then you will have a problem with cutter tools wearing down quick. Therefore, you will have problems with frequent auger teeth replacement due to the high rate of wear down. Therefore, you should ensure a smooth operation of the machine. You must also avoid pushing the auger attachment too hard since you damage the hydraulic system. Smooth is, therefore, essential for maintaining auger teeth in good condition as well as the hydraulic system.

Check the condition Of Wear Parts

As an operator, checking the condition of machine wear parts is essential. These are the parts that do the actual drilling work. They include the auger teeth, auger bits or screw bits and other parts. Due to the tough nature of the condition they are used in, auger wear parts are likely to wear down very fast. Therefore, they should be checked regularly for wear and tear. Keep the cutter tools sharp or make auger teeth replacement if necessary.

Leave a Reply

Your email address will not be published. Required fields are marked *